您好,我有两个 numpy 数组(在本例中代表深度和百分比深度剂量数据),如下所示:
depth = np.array([ 0. , 0.1, 0.2, 0.3, 0.4, 0.5, 0.6, 0.7, 0.8, 0.9, 1. ,
1.1, 1.2, 1.3, 1.4, 1.5, 1.6, 1.7, 1.8, 1.9, 2. , 2.2,
2.4, 2.6, 2.8, 3. , 3.5, 4. , 4.5, 5. , 5.5])
pdd = np.array([ 80.40649399, 80.35692155, 81.94323956, 83.78981286,
85.58681373, 87.47056637, 89.39149833, 91.33721651,
93.35729334, 95.25343909, 97.06283306, 98.53761309,
99.56624117, 100. , 99.62820672, 98.47564754,
96.33163961, 93.12182427, 89.0940637 , 83.82699219,
77.75436857, 63.15528566, 46.62287768, 29.9665386 ,
16.11104226, 6.92774817, 0.69401413, 0.58247614,
0.55768992, 0.53290371, 0.5205106 ])
绘制时给出以下曲线:
我需要找到 pdd 下降到给定值(最初为 50%)的深度。我尝试在 pdd 达到 100% 的点对数组进行切片,因为我只对之后的点感兴趣。
不幸的是,np.interp 似乎只能在 x 和 y 值都增加的情况下工作。
谁能建议我下一步应该去哪里?
请您参考如下方法:
如果我没理解错的话,您想在 pdd = 50.0 处对函数 depth = f(pdd) 进行插值。出于插值的目的,将 pdd 视为对应于您的“x”值,将 depth 视为对应于您的“y”值可能会有所帮助。
您可以使用 np.argsort按“x”的升序(即升序 pdd)对“x”和“y”进行排序,然后照常使用 np.interp:
# `idx` is an an array of integer indices that sorts `pdd` in ascending order
idx = np.argsort(pdd)
depth_itp = np.interp([50.0], pdd[idx], depth[idx])
plt.plot(depth, pdd)
plt.plot(depth_itp, 50, 'xr', ms=20, mew=2)
